Reference Manual

ManualsBrandsWuerth Elektronik eiSos ManualsElectronicsRadio module HVIN 1101102

Table Of Contents

Introduction
- Operational description
  - Key features
  - Connectivity
- Block diagram
- Ordering information
Electrical specifications
- Recommended operating conditions
- Absolute maximum ratings
- Power consumption
  - Static
  - Dynamic
- Radio characteristics
- Pin characteristics
Pinout
Quick start
- Minimal pin connections
- Antenna connection
  - On-board PCB antenna
  - External antenna
- Power up
- Quickstart example
Functional description
- State indication using the LED pins
- Sleep mode
- Identification of a Proteus-III device on the radio
- Connection based data transmission, with or without security
  - Further information for a secure connection setup
- Unidirectional connectionless data transmission using Beacons
- Energy-efficient distance estimation solutions
- Configure the module for low power consumption
- Start the direct test mode (DTM)
- Using the 2 MBit and LE Coded phy
- Connection setup using LE Coded phy
Host connection
- Serial interface: UART
  - Reset behaviour
The command interface
- Scan for other modules in range
- Setup connections
- Transmit and receive data
- Configuring the module and modifying the device settings
  - CMD_SET_REQ
    - Example 1
    - Example 2
  - CMD_GET_REQ
    - Example 1
- Manage the device state
- Run the Bluetooth test modes
  - CMD_DTMSTART_REQ
  - CMD_DTM_REQ
- Switching GPIOs by remote control
- Other messages
  - CMD_ERROR_IND
- Message overview
UserSettings - Module configuration values
- FS_DeviceInfo: Read the chip type and OS version
  - Example 1
- FS_FWVersion: Read the firmware version
  - Example 1
- FS_MAC: Read the MAC address
  - Example 1
- FS_BTMAC: Read the BLE conform MAC address
  - Example 1
- FS_SerialNumber: Read the serial number of the module
  - Example 1
- RF_DeviceName: Modify the device name
  - Example 1
  - Example 2
- RF_StaticPasskey: Modify the static passkey
  - Example 1
  - Example 2
- RF_SecFlags: Modify the security settings
  - Example 1
  - Example 2
- RF_SecFlagsPerOnly: Modify the security settings (Peripheral only mode)
  - Example 1
  - Example 2
- RF_ScanFlags: Modify the scan behavior
  - Example 1
  - Example 2
- RF_BeaconFlags: Interprete the advertising data
  - Example 1
  - Example 2
- RF_AdvertisingTimeout: Modify the advertising timeout
  - Example 1
  - Example 2
- RF_AdvertisingFlags: Configure the advertising packet
  - Example 1
  - Example 2
- RF_ScanFactor: Modify the scan factor
  - Example 1
  - Example 2
- RF_ScanTiming: Modify the scan timing
  - Example 1
  - Example 2
- RF_ConnectionTiming: Modify the connection timing
  - Example 1
  - Example 2
- RF_TXPower: Modify the output power
  - Example 1
  - Example 2
- RF_SPPBaseUUID: Configure the SPP base UUID
  - Example 1
  - Example 2
- RF_Appearance: Configure the appearance of the device
  - Example 1
  - Example 2
- UART_ConfigIndex: Modify the UART speed
  - Example 1
  - Example 2
- CFG_Flags: Configure the module
  - Example 1
  - Example 2
- DIS_ManufacturerName: Configure the manufacturer name
  - Example 1
  - Example 2
- DIS_ModelNumber: Configure the model number
  - Example 1
  - Example 2
- DIS_SerialNumber: Configure the serial number
  - Example 1
  - Example 2
- DIS_HWVersion: Configure the HW version
  - Example 1
  - Example 2
- DIS_SWVersion: Configure the SW version
  - Example 1
  - Example 2
- DIS_Flags: Configure the device information service
  - Example 1
  - Example 2
Timing parameters
- Reset and sleep
- BLE timing parameters
- Connection establishment
- Connection based data transmission
Peripheral only mode
- Reasons to use the peripheral only mode
- Restrictions
- How to use the peripheral only mode
- More information
  - Radio
  - UART
Remote GPIO control
- Supported GPIO_IDs for remote and local control
Customizing the Proteus-III
- DIS - Device information service
- UUID
- Appearance
Custom firmware
- Custom configuration of standard firmware
- Customer specific firmware
- Customer firmware
- Contact for firmware requests
Firmware update
- Firmware update using the SWD interface
- Firmware update using the Proteus-III OTA bootloader
  - Firmware update steps using the Nordic nRF Toolbox app
Firmware history
Design in guide
- Advice for schematic and layout
- Dimensioning of the micro strip antenna line
- Antenna solutions
Reference design
- EV-Board
- Trace design
Manufacturing information
- Moisture sensitivity level
- Soldering
- ESD handling
- Safety recommendations
Physical dimensions
- Dimensions
- Weight
- Module drawing
- Footprint
- Antenna free area
Marking
- Lot number
- General labeling information
Bluetooth SIG listing/qualification
- Qualification steps when referencing the Proteus-III
Regulatory compliance information
- Important notice EU
- Important notice FCC
- Conformity assessment of the final product
- Exemption clause
- FCC Compliance Statement
- IC Compliance Statement
- FCC and IC requirements to OEM integrators
  - Pre-certified antennas
- ARIB Declaration of conformity
  - Label
  - Certified antennas
Important notes
- General customer responsibility
- Customer responsibility related to specific, in particular safety-relevant applications
- Best care and attention
- Customer support for product specifications
- Product improvements
- Product life cycle
- Property rights
- General terms and conditions
Legal notice
- Exclusion of liability
- Suitability in customer applications
- Trademarks
- Usage restriction
License terms
- Limited license
- Usage and obligations
- Ownership
- Firmware update(s)
- Disclaimer of warranty
- Limitation of liability
- Applicable law and jurisdiction
- Severability clause
- Miscellaneous

22.4 Exemption clause . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 206

22.5 FCC Compliance Statement . . . . . . . . . . . . . . . . . . . . . . . . . . . 207

22.6 IC Compliance Statement . . . . . . . . . . . . . . . . . . . . . . . . . . . . 207

22.7 FCC and IC requirements to OEM integrators . . . . . . . . . . . . . . . . . 207

22.7.1 Pre-certiﬁed antennas . . . . . . . . . . . . . . . . . . . . . . . . . 209

22.8 ARIB Declaration of conformity . . . . . . . . . . . . . . . . . . . . . . . . . 210

22.8.1 Label . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 210

22.8.2 Certiﬁed antennas . . . . . . . . . . . . . . . . . . . . . . . . . . . 210

23 Important notes 211

23.1 General customer responsibility . . . . . . . . . . . . . . . . . . . . . . . . . 211

23.2 Customer responsibility related to speciﬁc, in particular safety-relevant ap-

plications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 211

23.3 Best care and attention . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 211

23.4 Customer support for product speciﬁcations . . . . . . . . . . . . . . . . . . 211

23.5 Product improvements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 212

23.6 Product life cycle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 212

23.7 Property rights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 212

23.8 General terms and conditions . . . . . . . . . . . . . . . . . . . . . . . . . . 212

24 Legal notice 213

24.1 Exclusion of liability . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 213

24.2 Suitability in customer applications . . . . . . . . . . . . . . . . . . . . . . . 213

24.3 Trademarks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 213

24.4 Usage restriction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 213

25 License terms 215

25.1 Limited license . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 215

25.2 Usage and obligations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 215

25.3 Ownership . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 216

25.4 Firmware update(s) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 216

25.5 Disclaimer of warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 216

25.6 Limitation of liability . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 217

25.7 Applicable law and jurisdiction . . . . . . . . . . . . . . . . . . . . . . . . . . 217

25.8 Severability clause . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 217

25.9 Miscellaneous . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 217