User's Manual

P-2000/C-2000/RT-2000
Installation Manual
Page 16 of 41 Publication No. 150-049106
P-2000 Installation Manual Rev. A
Oct 2003
(2) The installing agency will supply and fabricate all external cables. The connectors
are supplied separately and are listed in Section 1.F.
(3) The length and routing of the external cables must be carefrully studied and planned
before attempting actual installation. Avoid sharp bends and placing cables too
near other aircraft cables.
(4) Use only recommended wire sizes and wire type for interwiring. Wire sizes and wire
type are listed on the interwiring diagrams.
C. C-2000 Mechanical Installation
(1) Select the P-2000 mounting location. Insure that unit will be easily accessible and
clearly visible to the operator. The location should be free from excessive moisture,
vibration, heat and noise generating sources. The unit has standard Dzus mount
dimensions as shown in Figure 2-1. Allow adequate space and service loops for
installation of cables and connectors.
(2) The installing agency will supply and fabricate all external cables. The connectors
are supplied separately and are listed in Section 1.F.
(3) The length and routing of the external cables must be carefrully studied and planned
before attempting actual installation. Avoid sharp bends and placing cables too
near other aircraft cables.
(4) Use only recommended wire sizes and wire type for interwiring. Wire sizes and wire
type are listed on the interwiring diagrams.
D. RT-2000 Mechanical Installation
(1) Select the RT-2000 mounting location. The location should be free from excessive
moisture, vibration, heat and noise generating sources. The unit can be rigidly
mounted. Allow at least one inch of free air space around the top and rear of the unit
and one-half inch along each side. Allow adequate space for installation of cables
and connectors.
(2) Refer to Figure 2-3 for the RT-2000 mounting dimensions.
(3) Mark, punch, and drill the mounting holes. Care must be taken to avoid damage to
adjacent equipment or cables.
(4) Secure the mounting tray firmly in place.
(5) Secure the RT-2000 to the mounting tray and connect all appropriate connectors
taking care to apply the correct RF connector to the desired transceiver.