User's Manual

P-2000/C-2000/RT-2000
OPERATOR’S MANUAL
Page 32 of 40 Publication No. 150-049105
Operator’s Manual Rev. B
Dec 2004
CPS MODE
Loading Channel Memory
Programming the preset channels of the P-2000 must be performed with PC based program available from
MOTOROLA named CPS. Normally this procedure is accomplished by a technician familiar with this software
package since extensive knowledge is required to operate the Motorola software. As a note to the technician, no
RIB box is required between the PC and P-2000 since Wulfsberg has built this capability into its transceiver.
Please understand there are very specific requirements for the Motorola
module to function properly:
1. Zones must be set for a maximum of 16 channels per zone.
2. Do not use scan on any personality.
3. Do not change the button settings or menu items. Leave them to the
factory defaults.
4. Disable all messages such as display encryption key name on mode
change.
5. Do not have multiple programs operating on your computer that use the
same communication port as the Motorola CPS software.
6. Do not use identical channel names within the same zone.
Please review the P-2000 FAQ page on the Wulfsberg
website (www.wulfsberg.com) for the latest program
information.
* NOTE If programming a system that contains a C-2000, turn off the
C-2000 until the P-2000 has been successfully programmed.