User's Manual

P-2000/C-2000/RT-2000
OPERATOR’S MANUAL
Publication No. 150-049105 Page 35 of 40
Rev. C Operators Manual
July 2005
SYSTEM SETUP MODE
The P-2000 comes from the factory already configured for a normal installation, however, there are several options
the installer can select. These options are very simple to update. The process is as follows.
Ensure you are on the HOME PAGE and press the PROG button.
• Highlight the SYSTEM option and press the ENTER button. You will be prompted to enter password #3. This
password is available only in the installation manual and cannot be set by the user. After successful entry of
password 3 the SYSTEM SETUP page will be displayed.
• On System Setup Page 1, users can configure the Label field (instead of FM1 or FM2, the user could input
VHF1, MAIN, OPS or anything that helps the operators properly select transceivers), and the passwords.
Password #1 will not appear in any operations if it set to “0000”. Do not change Module or Crypto type as
these are factory only settings.
• To display page 2, highlight the NEXT option and press enter.