User's Manual

P-2000/C-2000/RT-2000
OPERATOR’S MANUAL
Page 40 of 40 Publication No. 150-049105
Operator’s Manual Rev. B
Dec 2004
Steps to Successful Setup and Operation
While we would like to pull products out of the box and immediately start to use them, this system is one that takes
just little work to get to that point. First READ THE OPERATORS MANUAL!!!! This will familiarize you with
the buttons and display pages of the system. The following checklist will help installers setup the P-2000 or C-
2000/RT-2000.
1. Note all part numbers of components in your system..
P-2000 Part Number = _______________________________________
C-2000 Part Number = _______________________________________
RT-2000 Part Number = _______________________________________
Please write down the frequency bands of the transceivers inside the P-2000/RT-2000.
FM #1 = ___________________
FM #2 = ___________________
2. Using the SYSTEM Programming page 2, select whether the unit will be operated in Single Mic Mode(only one
mic/headset port) or Dual Mic Mode (two independent mic/headset ports). Review the other options and
configure as desired. Return to the HOME page.
3. Put the P-2000/RT-2000 in CPS mode for FM 1.
4. Connect a PC to the programming port of the P-2000/RT-2000 and run the Motorola CPS software.
5. Using the CPS software, read the codeplug of FM 1. Save this first in case you need to return to factory
settings.
6. Program personalities and Zones/Channels. It is very important to use good channel identifiers so operators can
efficiently determine the purpose of the channel. Whenever possible, use the same channel name the ground
units use so that when calling out channel changes both the aircraft and the ground units can use the same
channel names. These steps require significant knowledge of the Motorola software. We encourage enlisting
the help of someone familiar with Motorola CPS software to successfully program the internal transceivers.
7. Save the modified codeplug on the hard drive and then download it into FM1.
8. Do the above for FM #2 if applicable.
9. Upon the exit from CPS mode, the P-2000/RT-2000 will ask if you wish go into “LEARN” mode. If you’ve
added, deleted, or changed the archive in any way, say yes. If you just looked at the archive but didn’t change
it, then just say no. When the unit is in “LEARN” mode, the internal computer is interrogating the transceiver
module for information about channels that were programmed during CPS operations. Wait until the display
indicates successful completion of this process.
10. Turn power on and off to begin a full start process and validate that all channels programmed during CPS are
now functional on both FM #1 and FM #2 transceivers.