User's Manual

FLITELINE AVIONICS SYSTEM
PILOT’S GUIDE
Page 22 Publication No. 150-047012
Dec 2005 Rev. D
CVN-252 Controls (Series III and FliteLine Interface continued…)
108.15
ACT
1
ON BRGRAD

110.20
When the NAV radio is turned on, the last display
before turnoff is displayed again.
The upper line of the display always shows the
active frequency (indicated by the letters ACT. The
lower display may show the standby frequency,
digital radial or bearing, or LOC annunciation,
depending on the FUNCTION SELECTOR setting.
When two frequencies are displayed, rotating the
FREQUENCY knobs changes the bottom (standby)
frequency.
084.0°
ACT
1
ON BRGRAD

111.40
VOR "From"
VOR Freq.
If the FUNCTION SELECTOR switch is set to RAD
when a VOR frequency is active (shown on the top
line), the bottom line displays the radial the aircraft is
on FROM the VOR station.
In this mode, the FREQUENCY TRANSFER button
is disabled.
264.0°
ACT
1
ON BRGRAD

111.40
VOR "To"
VOR Freq.
If the FUNCTION SELECTOR switch is set to BRG
when a VOR frequency is active (shown on the top
line) the bottom line displays the bearing TO the
VOR station.
In this mode, the FREQUENCY TRANSFER button
is disabled.