User's Manual

FLITELINE AVIONICS SYSTEM
PILOT’S GUIDE
Publication No. 150-047012 Page 63
Rev. D Dec 2005
FliteLogic EFIS Tuning Features
General Description
The CVC-152, CVN-252, and CCN-955 are designed to integrate with the Chelton FliteLogic Electronics Flight
Instrument System (EFIS). The Control Displays receive COM and NAV tuning frequencies from the EFIS
database to reduce pilot workload.
Operating the Control Displays with EFIS
1. On the EFIS, display the information for the facility (see Waypoint Information (NavData), page 5-38
EFIS Manual).
2. On the EFIS, turn the control knob to highlight the desired frequency.
3. Menu functions will appear as appropriate to send the frequency to the com or nav radios.
3. On the EFIS, press TO COM1 or TO COM2 (or TO NAV1 or TO NAV2) to send the frequency to the
standby position of the COM (or NAV) radio.
4. On the Control Display, when in ARINC410 mode, observe the standby frequency flashes and the
frequency instantly changes.
5. On the Control Display, when in Series III or FliteLine mode, observe the standby frequency briefly
flashes the word EFIS for up to 2 seconds while the frequency synchronizes between the Control
Display and Radio.
4. On the EFIS, Press BACK or EXIT when finished.
5. On the Control Display, press the frequency transfer button (right pushbutton) to move the frequency
from standby to active.
EFIS and Control Display Integration notes:
1. The standby area will not flash when in COM and NAV modes where the actual standby frequency is
not normally displayed
a. NAV – HLD, BRG, RAD,
b. COM –
2. The control display executes the last EFIS frequency update upon entering a mode in which the standby
frequency is displayed.