User's Manual

C-5000 COMMUNICATION MANAGEMENT CONTROLLER
INSTALLATION MANUAL
Publication No. 150-041118 Page 7-3
(4) At this point the C-5000 must have its configuration programmed. Using either the
Wulfsberg RP software or the front panel knobs and buttons, program the required
system configuration data.
(5) If either of the transceivers is an RT-5000 and has a part number with the last 4
digits greater than -05XX (e.g. -0611, -0711 etc.), the internal transceiver module(s)
(ITM) must be programmed using Motorola CPS software. See the C-5000
Operator's manual for detailed instructions on how to put the RT-5000 into the mode
that allows a computer to communicate with the Motorola Software. Motorola
Software must be purchased from Motorola.
(5) The final programming step is to program the desired preset channels into the
C-5000 using either the Wulfsberg RP software or using the front panel knobs and
buttons. Start with a limited set that will test the basic operations of the system such
as:
• Analog FM Modulation at a frequency in each band: 30-50, 138-174, 225-
400,400-512, 806-870.
• AM Modulation at a frequency in each band: 118-137, 225-400.
• P25 or Trunking Modulation in the band specified by the radio part number.
• Encryption if available in the transceiver.
(a) On the C-5000, tune transceiver system #1 to the manual channel. Using the
"EDIT" page on the C-5000 tune the manual channel for 30 MHz Rx and Tx
frequency, set Tx Power to Hi, and the Bandwidth to "S", no subaudible tone.
Press the "HOME" button to return to the "HOME" display page.
(b) Press the "Test" Button and verify the squelch indicator lights up and noise
audio is heard in the headsets. Adjust RT #1 volume control (the small knob on
the left side) so that the noise can be heard.
(c) If a single channel guard receiver or synthesized guard receiver is present
(-0201, -0301, -0401, -0501), select the guard receiver and press the "TEST"
button. Verify the squelch indicator lights and audio is heard.
(d) If a MTM Guard receiver is present (-0611 and higher), channel the C-5000 to
a channel that uses the VHFXXX ITM, press the "TEST" button. Verify the
squelch indicator lights and audio is heard.
(e) If a second transceiver is in the system, put the cursor on the bottom line,
select the manual channel for RT #2 and input the same settings that were
done to RT #1. Press the "Test" button to open squelch and verify the squelch
indicator for transceiver #2 lights and audio is heard. If an audio panel is being
used, make sure selector switches are in the correct position to hear both
Primary (RT #1) and Secondary headset audio (RT #2).
Rev C Section 7 – System Checkout
May 2006