User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
S Y S T E M S E T U P M O D E
H O M E = E X I T 2 = R E V I E
W
(14) Press the HOME button to exit system configuration, or the MODE button to review current
settings.
B. Configuring the C-5000 to Control an RT-5000
This section covers the radio setup sub-menu pages. Refer to the section on configuring the C-5000
for details on how to reach these menu pages. This section assumes the C-5000 part number you
entered indicated an RT-5000 was present for Radio #1. We pick up at the following display page.
S E T U P : 2 = N E X T 3 = B A C K
E N T E R = SETUP RAD I O # 1
(1) Press the ENTER button to begin configuring the RT-5000.
S Y S # 1 : 2 = N E X T 3 = B A C K
R T - 5 0 0 0 P / N = 5 01 1
(2) Use the cursor/value knobs to input the last four digits of your RT-5000’s part number. Press
the MODE button to display the next menu page.
Note
: If the RT-5000 part number you enter is rejected, and you are sure you are entering a
valid part number, it is likely your flavor of RT-5000 was created after the C-5000
software was released. Since the C-5000 software has no knowledge of this part
number, it will reject it. Until your C-5000 software gets updated, you may enter an
“equivalent” part number. Refer to Appendix D for a complete list.
S Y S # 1 : 2 = N E X T 3 = B A C K
E N T E R = SETUP GUARD # 1
(3) This page will only display if the RT-5000 part number entered indicates a Guard receiver is
present. Pressing the ENTER button invokes the preset channel programming menu pages
for the Guard channel. Refer to the section on programming a preset channel for details since
programming a Guard channel is very similar to programming a preset channel.
Publication
No. 150-041102 Page 20 of 88
Rev E C-5000 Operators Manual