User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
(c) Emergency Revert – Allows the user to select a preset used to TX data in Emergency
Mode for the Conventional Personality. This menu is only available when Emergency
Enable is ENABLED in the Emergency Menu.
(d) Emergency – Allows the user to enable the Emergency Enable for the Conventional
Personality. Normally set to DISABLED.
(e) Repeater Access – Allows the user to enable Repeater function for the Conventional
Personality.
Pretime (ms): 200
(f) TX Multiplier – Allows the user to modify Emergency Mode key-up limits for the
Conventional Personality.
(g) Advanced – Allows the user to modify Advanced settings for the Conventional
Personality.
Publication
No. 150-041102 Page 58 of 88
Rev E C-5000 Operators Manual