User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
12. Zone Channel Assignment
– These menus are used to assign any of the possible 255 Personalities
to a specific zone and channel, as well as enter the TX and RX frequencies, and assign the
Personality Type as either Conventional (Cnv) or Trunking (Trk). Please follow the CPS programming
notes outlined in Section 3 of this manual.
Publication
No. 150-041102 Page 77 of 88
Rev E C-5000 Operators Manual