User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
(8)
Use the cursor/value knobs to input the last four digits of your C-5000’s part number. Press
the MODE button to display the next menu page.
S E T U P : 2 = N E X T 3 = B A C K
E N T E R = SETUP RAD I O # 1
(9) You can press the ENTER button to configure radio 1. Refer to the sections on configuring
RT-5000 and non-RT-5000 radios for details on these sub-menu pages. Press the MODE
button to display the next menu page.
S E T U P : 2 = N E X T 3 = B A C K
E N T E R = SETUP RAD I O # 2
(10) You can press the ENTER button to configure radio 2. Refer to the sections on configuring
RT-5000 and non-RT-5000 radios for details on these sub-menu pages. Press the MODE
button to display the next menu page.
S E T U P : 2 = N E X T 3 = B A C K
E N T E R = C H G P A S S
W
OR D 1
(11) You can press the ENTER button to change the system configuration password. Refer to the
section on changing passwords for details on these sub-menu pages. Press the MODE
button to display the next menu page.
S E T U P : 2 = N E X T 3 = B A C K
E N T E R = C H G P A S S
W
OR D 2
(12) You can press the ENTER button to change the programming password. Refer to the section
on changing passwords for details on these sub-menu pages. Press the MODE button to
display the next menu page.
S E T U P : 2 = N E X T 3 = B A C K
E N T E R = SETUP MI SC.
(13) You can press the ENTER button to change miscellaneous system properties, such as
system encryption, side-tones, and de-emphasis. Refer to the section on miscellaneous
configuration options for details on these sub-menu pages. Press the MODE button to display
the next menu page.
Publication
No. 150-041102 Page 19 of 88
Rev E C-5000 Operators Manual