User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
E. Setting Miscellaneous Configuration Options
This section covers the miscellaneous setup sub-menu pages. Refer to the section on configuring the
C-5000 for details on how to reach these menu pages. We pick up at the following display page:
S E T U P : 2 = N E X T 3 = B A C K
E N T E R = SETUP MI SC.
(1) Press the ENTER button to begin configuring miscellaneous options.
S E T U P : 2 = N E X T 3 = B A C K
D I M K E Y M O D E - M UT E
(2) This page only appears if utilizing software 11 and above. Use the cursor/value knobs to tell
the C-5000 if the DIM key should be used for the DIM function or the MUTE function. When
configured for MUTE, pressing the DIM key will mute audio from the non-active receivers.
Press the MODE button to display the next menu page.
S E T U P : 2 = N E X T 3 = B A C K
M I C MODE -SIN G L E
(3) This page only appears if using software 11 and above. Use the cursor/value knobs to tell the
C-5000 if it has one or two microphones connected to it. When configured for SINGLE, the C-
5000 will operate in single-mic mode. Press the MODE button to display the next menu page.
S E T U P : 2 = N E X T 3 = B A C K
S Y S T E M E N C R Y P T - N O
(4) Use the cursor/value knobs to tell the C-5000 if external encryption is available. This option
pertains only to a separate encryption device, i.e. one that is not part of the C-5000 or any of
the transceivers. A KY-58 device is a typical example. Press the MODE button to display the
next menu page.
S E T U P : 2 = N E X T 3 = B A C K
C - 5 0 0 0 S I D E T O N E - N O
(5) This page only appears if system encryption is available. Use the cursor/value knobs to tell
the C-5000 if it should use side-tones. Press the MODE button to display the next menu
page.
Publication
No. 150-041102 Page 26 of 88
Rev E C-5000 Operators Manual