User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
(i) ASTRO 25 Channel ID - This menu allows you to view the Channel ID settings for the
Trunking System.
(j) 700_800 ASTRO Control Channels – This menu allows you to modify the Control
Channel settings for the ASTRO 25 mode.
(k) Data – This menu allows you to modify the Data Settings for the Trunking System.
(l) ASTRO 25 Omnilink – This menu allows you to modify the Omnilink settings for ASTRO
25 mode.
(m) ASTRO 25 Site Alias – This menu allows you to modify the Site Alias settings for the
ASTRO 25 mode.
(n) 700_800 Control Channels – This menu allows you to modify the Control Channel
settings.
Publication
No. 150-041102 Page 70 of 88
Rev E C-5000 Operators Manual