User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
3. FLITECOMM
This product line is no longer manufactured, but remains in wide use. It consisted of the RT-7200,
RT- 9600, and RT-9600F transceivers. They were available with a two-channel, crystal-controlled,
Guard Receiver that could be user-specified for any Guard frequency between 138.000 and 173.9950
MHz (RT-7200) or between 150.000 and 173.9975 MHz (RT-9600/9600F). They were equipped with
CTCSS tones on both the Main and Guard Receivers.
C. Steps to Successful Setup and Operation
IMPORTANT!!! CPS PROGRAMING NOTES:
ZONE 1 – CHANNEL 1 MUST BE ASSIGNED TO CONVENTIONAL (CNV) PERSONALITY 1, MUST
USE DIFFERENT RECEIVE AND TRANSMIT FREQUENCIES, AND HAVE “DIR/TALKAROUND
ENABLED”.
ZONES MUST BE SET FOR A MAXIMUM OF 16 CHANNELS PER ZONE, EXCEPT WHEN
UTILIZING SINGLE ZONE SETTINGS.
DO NOT ENABLE SCAN ON ANY PERSONALITY.
DO NOT CHANGE MENU OR DISPLAY OPTIONS. USE FACTORY SETTINGS ONLY.
WHEN MIXING DIRECT AND NONDIRECT CHANNELS WITHIN A ZONE, CHANNEL 1 OF THAT
ZONE MUST BE ASSIGNED TO CONVENTIONAL (CNV) PERSONALITY 1, MUST BE A DUPLEX
FREQUENCY, AND MUST HAVE “DIR/TALKAROUND” ENABLED.
The following checklist will help installers and initial users setup the C-5000 and RT-5000.
(1) Connect the C-5000 to the transceivers. Note part numbers of the Control Head and all
transceivers.
C-5000 Part Number = 31300-1X02- ____________
Radio #1 Model # = _________________ Part Number = ____________________
Radio #2 Model # = _________________ Part Number = ____________________
(2) Configure the C-5000 using the steps outlined in section 5 of this manual. You must know
the last four digits of the C-5000 part number and the last four digits of any RT-5000’s or the
model type of any Flexcomm/Flitecomm Transceiver.
Note:
Your C-5000 software may not be updated to include all versions of RT-5000’s.
Use Appendix D to find alternative RT-5000 part numbers to enter.
(3) If Radio #1 is an RT-5000 that has a MTM Guard Receiver (-06XX or greater) connect a PC
to the 9-pin programming port of the RT-5000 and run the Motorola CPS software.
(4) Put the C-5000 in CPS mode for radio #1 and select the first ITM (Internal Transceiver
Module) to appear.
Publication
No. 150-041102 Page 13 of 88
Rev E C-5000 Operators Manual