User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
(5)
Using the CPS software, read the codeplug out of the ITM. Save this first as a back-up in
case you need to return to the factory setting.
(6) Modify system settings for your application. Program the personalities and assign
Zone/Channels. It is important to use good channel identifiers so CPS operators can
efficiently determine the purpose of the channel. Whenever possible, use the same channel
names as used by the ground personnel to avoid using the wrong preset.
Note:
These steps require significant knowledge of the Motorola software. We encourage
enlisting the help of someone familiar with Motorola CPS software to successfully program
the ITM.
(7) Save the modified codeplug to the hard drive and load it into the ITM.
(8) Do the above for the second ITM if there is one in Radio #1.
(9) Do the above for Radio #2 only if it’s an RT-5000 with an MTM Guard (-06XX or greater).
(10) Using the front panel, or better yet the Cobham RpWin software, program all preset channels
into the C-5000, including the ones programmed into each ITM module in the steps above.
(11) Using a communication analyzer or over the air test, verify that each radio and channel
operates properly.
D. Refer to Pilots Guide 150-041103 for C-5000 operations
Publication
No. 150-041102 Page 14 of 88
Rev E C-5000 Operators Manual