User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
5.
Configuring the C-5000
A. Configuring the C-5000
Although Cob
ham highly recommends using the PC based Remote Programmer software to specify
the C-5000’s configuration, it can be specified from the front panel. The process is as follows.
(1) Ensure you are on the HOME PAGE.
(2) Press the PROG button. You will be prompted to enter a password, as follows.
E N T E R P A S S
W
ORD 2
# = . . .. <ENTER>
(3) Input the appropriate password using the keypad and press the ENTER button.
Note:
Password 2 is “2222” by default.
(4) Press the MODE button until the following display page appears:
P R O G : 2 = N E X T 3 = B A C K
< E N T E R >= CFG SYSTE M
(5) Press the ENTER button. You will be prompted to enter a password, as follows:
E N T E R P A S S
W
ORD 1
# = . . .. <ENTER>
(6) Input the appropriate password and press the ENTER button.
Note:
Password 1 is “1111” by default.
(7) The display will appear as follows:
S E T U P : 2 = N E X T 3 = B A C K
C 5 0 0 0 P / N = 1 220
Publication
No. 150-041102 Page 18 of 88
Rev E C-5000 Operators Manual