User's Manual

FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
S E T UP RAD I O # 1
H O M E = E X I T 2 = R E V I E
W
(8) Press the HOME button to exit the radio setup menu pages, or press the MODE button to
review the current settings.
C. Configuring the C-5000 to Control A Non RT-5000
This section covers the radio setup sub-menu pages. Refer to the section on configuring the C-5000
for details on how to reach these menu pages. This section assumes the C-5000 part number you
entered indicated a Flitecomm or Flexcomm I radio was present on radio #2. We pick up at the
following display page:
S E T U P : 2 = N E X T 3 = B A C K
E N T E R = SETUP RAD I O # 2
(1) Press the ENTER button to begin configuring the radio.
S Y S # 2 : 2 = N E X T 3 = B A C K
R T - 30 PRESENT - N O
(2) Use the cursor/value knobs to tell the C-5000 if an RT-30 is present. Press the MODE button
to display the next menu page.
S Y S # 2 : 2 = N E X T 3 = B A C K
R T - 1 1 8 PRESENT - N O
(3) Use the cursor/value knobs to tell the C-5000 if an RT-118 is present. Press the MODE
button to display the next menu page.
S Y S # 2 : 2 = N E X T 3 = B A C K
R T - 1 3 8 PRESENT - Y E S
(4) Use the cursor/value knobs to tell the C-5000 if an RT-138 is present. Press the MODE
button to display the next menu page.
Publication
No. 150-041102 Page 22 of 88
Rev E C-5000 Operators Manual