User's Manual

FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
S Y S # 2 : 2 = N E X T 3 = B A C K
G U A R D # 1 PRESENT - Y E S
(11) Use the cursor/value knobs to tell the C-5000 if a Guard is present. Press the MODE button
to display the next menu page.
S Y S # 2 : 2 = N E X T 3 = B A C K
E N T E R = SETUP GUARD # 1
(12) This page only appears if a guard is present. Press the ENTER button to configure the first
Guard channel. Refer to the preset channel programming section for details on the menu
pages that appear. Press the MODE button to display the next menu page.
S Y S # 2 : 2 = N E X T 3 = B A C K
G U A R D # 2 PRESENT - Y E S
(13) This page only appears if a second Guard is possible. Use the cursor/value knobs to tell the
C-5000 if a second Guard is present. Press the MODE button to display the next menu page.
S Y S # 2 : 2 = N E X T 3 = B A C K
E N T E R = SETUP GUARD # 2
(14) This page only appears if a second guard is present. Press the ENTER button to configure
the second Guard channel. Refer to the preset channel programming section for details on
the menu pages that appear. Press the MODE button to display the next menu page.
S Y S # 2 : 2 = N E X T 3 = B A C K
T O N E B OARD CTCSS - N O
(15) Use the cursor/value knobs to tell the C-5000 if an internal CTCSS tone board is
present.(Represented by a “3” in the C-5000 part number, i.e. 31300-XXXX-X333). Press the
MODE button to display the next menu page.
S Y S # 2 : 2 = N E X T 3 = B A C K
T O N E B OARD DCS - N O
Publication
No. 150-041102 Page 24 of 88
Rev E C-5000 Operators Manual