User's Manual

FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
(16
) Use the cursor/value knobs to tell the C-5000 if an internal DCS tone board is present.
(Represented by a “3” in the C-5000 part number, i.e. 31300-XXXX-X333). Press the MODE
button to display the next menu page.
S E T UP RAD I O # 2
H O M E = E X I T 2 = R E V I E
W
(17) Press the HOME button to exit the radio setup menu pages, or press the MODE button to
review the current settings.
D. Setting Passwords
This
section covers the password setup sub-menu pages. Refer to the section on configuring the C-
5000 for details on how to reach these menu pages. This section assumes we want to change
password 1. The process is the same for password 2. We pick up at the following display page.
S E T U P : 2 = N E X T 3 = B A C K
E N T E R = C H G P A S S
W
OR D 1
(1) Press the ENTER button to begin the password changing process. The display will appear as
follows:
E N T E R N E
W
PASS
W
OR D 1
# = . . .. <ENTER>
(2) Use the keypad to input the new password, and press the ENTER button.

B A C K V E R I F Y I N P U T
# = . . .. <ENTER>
(3) Use the keypad to re-input the new password, and press the ENTER button. This second
entry is for verification. If you entered an inconsistent password, your input will be erased,
and you may try again. Once you have entered the same password on both pages, it will be
changed, and the display will revert to the following:
S E T U P : 2 = N E X T 3 = B A C K
E N T E R = C H G P A S S
W
OR D 1
Publication
No. 150-041102 Page 25 of 88
Rev E C-5000 Operators Manual