User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
S E T U P : 2 = N E X T 3 = B A C K
C - 5 0 0 0 D E E M P H - N O
(6) This page only appears if system encryption is available. Use the cursor/value knobs to tell
the C-5000 if it should use de-emphasis. Press the MODE button to display the next menu
page.
M I SC SETUP
H O M E = E X I T 2 = R E V I E
W
(7) Press the HOME button to exit the miscellaneous configuration menu pages, or the MODE
button to review current settings.
F. Configuring the C-5000 Using a PC
Cob
ham highly recommends using the PC based Remote Programmer (RP) software to specify the
C-5000’s configuration. The Remote Programmer software offers several advantages over using
theC-5000’s front panel which includes:
(1) Allowing you to specify a C-5000’s configuration in less time.
(2) Enhanced error checking reduces the likelihood of specifying an incorrect configuration.
(3) A configuration can be specified once and loaded to multiple C-5000’s, saving huge amounts
of data entry time.
(4) Configurations can be saved, archived, and backed-up, reducing the likelihood of lost data.
(5) Configurations can be uploaded from the C-5000’s as well, saving data entry time on existing
configurations.
Refer to the Remote Programmer software’s user manual 150-041374 for details on how to specify C-
5000 configurations in RpWin.
G. Downloading a Configuration from RP into the C-5000
The C-50
00 continuously polls the data port on the front panel for incoming data, so all the user has
to do is initiate the download from RpWin. Refer to RpWin’s user manual for details on how to initiate
a download. Once the communication channel is open, the C-5000’s display will change to the
following:
M E M O RY TRANSFER
R E C E I V I NG BLOCK= 0 0 0
Publication
No. 150-041102 Page 27 of 88
Rev E C-5000 Operators Manual