User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
The 3-digit he
xadecimal number to the right of the display on the lower line will increment from 000 to
2FF while the download is in progress. When the download is complete, the C-5000 will automatically
restart.
H. Uploading a Configuration from the C-5000 into RpWin
The C-50
00’s current configuration can be uploaded into the RpWin software as follows:
(1) From the HOME page, press the PROG button, and enter the appropriate password.
(2) Press the MODE button until the following display page appears:
P R O G : 2 = N E X T 3 = B A C K
< E N T E R > = R P L O A D
(3) Press the ENTER button to display the following page:
M E M O RY TRANSFER
S T A R T SENDING
(4) Ensure the serial cable is connected to both the PC and the C-5000. Ensure the RpWin
software is ready to receive data. Refer to RpWin’s user manual for details on how to prepare
RpWin to receive data. Press the LOWER SOFT button on the C-5000 to initiate the transfer.
Once the communication channel is open, the C-5000’s display will change to the following:
M E M O RY TRANSFER
S E N D I NG BLOCK= 0 0 0
(5) The 3-digit hexadecimal number to the right of the display on the lower line will increment
from 000 to 2FF while the upload is in progress. When the upload is complete, the C-5000’s
display will return to the following:
P R O G : 2 = N E X T 3 = B A C K
< E N T E R > = R P L O A D
(6) Press the HOME button to return to the HOME PAGE.
Note:
You will most likely want to save the uploaded data to a disk file on the PC. Refer to
RpWin’s user manual (150-041374) for details on how to do this.
Publication
No. 150-041102 Page 28 of 88
Rev E C-5000 Operators Manual