User's Manual

FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
I. Entering CPS Load M
ode
Digital RT-5000’s must have the ITM(s) loaded with Motorola CPS before being able to TX/RX on
digital channels. Enter into CPS Load Mode by doing the following:
(1) From the HOME page, press the PROG button, and enter the appropriate password.
(2) Press the MODE button until the following display page appears:
P R O G : 2 = N E X T 3 = B A C K
< E N T E R > = C P S L O A D
(3) Press ENTER button to enter the CPS LOAD screen:

S T A R T C P S L O A D
R A D I O = 1 I T M = V H F 1 3 8
(4) Use the cursor to select either Radio 1 or 2 (if available), and between VHF or UHF ITM
depending on RT-5000 model number:

S T A R T C P S L O A D
R A D I O = 1 I T M = U H F 8 0 0
(5) Press START to open the CPS data lines and communicate between the laptop and the RT-
5000. When finished press END, and HOME twice to return:

E N D CPS LOAD
R A D I O # 1 I N C P S M O D E
J. KVL Load
In order to load encryption keys using a KVL data loader, you must enter KVL LOAD MODE by
performing the following procedures:
(1) From the HOME page, press the PROG button, and enter the appropriate password.
(2) Press the MODE button until the following display page appears:
Publication
No. 150-041102 Page 29 of 88
Rev E C-5000 Operators Manual