User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
P R O G : 2 = N E X T 3 = B A C K
< E N T E R > = K V L L O A D
(3) Press ENTER button to enter the KVL LOAD screen:
S T A R T K V L L O A D
R A D I O = 1 I T M = V H F 1 3 8
(4) Use the cursor to select either Radio 1 or 2 (if available), and between VHF or UHF ITM
depending on RT-5000 model number:
S T A R T K V L L O A D
R A D I O = 1 I T M = U H F 8 0 0
(5) Press START to open the KVL data lines and load the encryption keys into the RT-5000.
When finished press END, and HOME twice to return:
E N D KVL LOAD
R A D I O # 1 I N K V L M O D E
NOTE: Unit power must be cycled BEFORE
utilizing the radio for communications after
performing a key load.
K. KEY Erase
In order to erase loaded encryption keys, you must enter KEY ERASE MODE by performing the
following procedures:
(1) From the HOME page, press the PROG button, and enter the appropriate password.
(2) Press the MODE button until the following display page appears:
Publication
No. 150-041102 Page 30 of 88
Rev E C-5000 Operators Manual