User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
P R O G : 2 = N E X T 3 = B A C K
< E N T E R > = K E Y E R A S E
(3) Press ENTER button to enter the KEY ERASE screen:
S T A R T KEY ERASE
R A D I O = 1 I T M = V H F 1 3 8
(4) Use the cursor to select either Radio 1 or 2 (if available), and between VHF or UHF ITM
depending on RT-5000 model number:
S T A R T KEY ERASE
R A D I O = 1 I T M = U H F 8 0 0
(5) Press START to erase the encryption keys. When finished press END, and HOME twice to
return:
E N D KEY ERASE
R A D I O # 1 K E Y S E R A S E D
6. CPS Software Description and Programming
A. Before You Begin
To pro
gram the ITM(s) inside the RT-5000 the user must use a Windows based PC and Motorola’s
CPS software. Users must obtain their own copies of the software from Motorola as Cobham cannot
supply it. The programming of the ITM requires three basic steps. First, enter the information that has
to do with the setup of the way the RT-5000 communicates with the ITM. Second enter channel
information, or what Motorola calls “Personalities”, and finally assign the personalities to Zones and
Channels. It may help tremendously to enlist the help of an experienced CPS programmer.
Note:
Do Not simply write a portable file into the RT-5000 because this will overwrite data that
should not be altered.
If your agency uses Motorola XTS-X000 model handhelds, the simplest way to get started is to use
an archive from a known properly programmed XTS-X000. Then transfer a single channel to the
Publication
No. 150-041102 Page 31 of 88
Rev E C-5000 Operators Manual