User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
resident archive stored in the RT-5000 ITM from the factory. Add more channels once the first one is
proven.
Alternatively, the ITM comes from the factory with all the necessary information loaded in it for basic
operation. The user only needs to load system information such as USER ID’s, personalities,
and zone/channel allocation. Once an archive for an ITM is established, it can be cloned to other
ITM’s in other RT-5000’s of the same flavor.
The CPS software only allows the programmer to see and change functions that are available with
the hardware it is trying to program. As such, not all of the screens listed will be seen for every
model of ITM.
There are (2) versions of CPS that may apply to the RT-500
0 depending upon P/N as follows:
RT-5000 P/N 400-015525-0611 through -3511 uses CPS for XTS-3000 Portable radios. CPS P/N
RVN4182, which is 1 portion of a 2 disk set ordered under P/N RVN4184.
Note: There is no need for a RIB (Radio Interface Box) when using the RT-5000. The RIB is
already built into the radio.
RT-5000 P/N 400-015525-5011 and above uses CPS for XTS-5000 Portable Radios. CPS P/N
RVN4181, which is 1 portion of a 2 disk set ordered under P/N RVN4186.
Motorola CPS Ordering Information:
North American Customers: 1-800-422-4210
U.S.A. Federal Customers: 1-800-826-1913
International Customers: 1-847-538-8023
B. CPS Code PMA File Details
For a detailed description and help understanding CPS and the numerous options within you may
refer to the built in CPS help tool and tutorials. Further definition of each entry may be obtained by
pressing F1 with the entry highlighted on the screen.
Note: The following is a general guideline for programming the RT-5000 ITM’s using the CPS
software. Not all of the RT-5000 flavors will follow the same settings as outlined in this
manual due to various setting requirements for each specific flavor. Please remember
to never modify the Controls and Display and Menu Options unless instructed to do so, as
they are set at the factory per the RT-5000 flavor requirement.
7. Radio Information
– Contains key elements describing the configuration of the module.
Publication
No. 150-041102 Page 32 of 88
Rev E C-5000 Operators Manual