User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
(1)
Phone Configuration – This menu allows you to modify the radio’s Phone configuration
settings applied to Conventional and Trunking personalities.
(2) DTMF Codes – This menu allows you to configure the codes used by the radio when utilizing
a Phone System.
(3) Phone Number – This menu allows you to select the DTMF number for the Phone Number
used by the radio.
F. Secure –The settings in these menus control the overall behavior of the radio when operating in
the secure mode.
Note:
Some of these settings will vary depending on the encryption system. Settings should be
as follows:
(1) Secure Configuration – Contains menus to modify secure TX and RX elements.
(a) General – This menu allows you to modify the General options that apply to the Secure
Configuration.
(b) ASTRO OTAR –This page controls all ASTRO (Digital) specific OTAR settings.
Publication
No. 150-041102 Page 47 of 88
Rev E C-5000 Operators Manual