User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
B. MPL – Allows you to configure the Multiple Private Line setting.
(1) MPL Configuration – This menu allows you to modify the General MPL configuration settings.
(2) MPL List – This menu allows you to select a MPL from the current available MPL entries.
Note: DO NOT enable this option.
C. Conventional Personality – Contains the assigned personalities and the configurations for each.
(1) RX Options – This menu allows you to modify the Conventional Personality’s RX settings.
The Receive Only Box allows the user to make the personality a Receive Only Personality.
Publication
No. 150-041102 Page 52 of 88
Rev E C-5000 Operators Manual