User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
This box is n
ormally DISABLED. The user may also designate the RX Voice/Signal Type as
either ASTRO, Non-ASTRO, or Mixed Mode which will allow you to RX in both ASTRO and
Non-ASTRO mode. Utilize the Squelch (Fine Tune) to adjust the squelch level.
(2) TX Options – This menu allows you to modify the Conventional Personality’s TX settings.
The user may define the TX Voice/Signal Type as ASTRO or Non-ASTRO only if the RX
Voice/Signal Type was selected as Mixed Mode. The user may also select the Transmit
Power Level as either High or Low.
Publication
No. 150-041102 Page 53 of 88
Rev E C-5000 Operators Manual