User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
(3) Signaling - This menu allows you to modify the Conventional Personality’s Signaling
System. The Signaling Type may be None, MDC, Quick-Call II, or DTMF.
(4) MDC – This menu controls Selective Calling and Paging features of the radio, along with
control of the transmit function when other signals are present on the frequency. Please
note these options are only available if MDC is selected as the Signaling Type in the
Signaling menu. Leave all settings as shown below:
Publication
No. 150-041102 Page 54 of 88
Rev E C-5000 Operators Manual