User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
(5) Secure – This menu allow you to modify the Conventional Personality’s Secure options. The
user may select Clear or Secure in the Secure/Clear Strapping option and may select either
DES-XL, OTAR, or ASTRO OTAR.
(6) Secure II – This menu allows you to modify the Conventional Personality’s secure TX and
encoded RX operations. The user may select a key in the Voice Key Selection as well as
select Strapped in the Key Strapping option.
(7) RAC – This menu allows you to modify the Conventional Personality’s Repeater Access.
(8) Phone – This menu allow you to modify the Conventional Personality’s Phone code to use
the radio with a Phone System.
(9) Smart PTT – This feature is not enabled – Leave set to DISABLED.
(10) Scan – This menu allows you to assign the Conventional Personalities to a Scan List. For
Vote scan operations users must select a valid scan list and ENABLE Automatic Scan.
Note:
The Vote Scan feature is not available in all RT-5000 models.
Publication
No. 150-041102 Page 55 of 88
Rev E C-5000 Operators Manual