User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
E. Statu
s Alias List – This is used to configure various short status messages to send via the radio.
This feature is currently not used in the FLEXCOMM System.
F. MDC – This is used to configure the MDC operations of the radio.
(1) MDC Call List - This allows you to modify MDC call list menus.
(2) MDC Repeater ID List – This allows you to modify IDs for repeaters.
(3) MDC System – This menu controls the setup for MDC (Analog) operations. With the
exception of the Primary ID, the settings shown on this screen must remain as depicted.
The Primary ID is the Unique ID (UID) assigned to the radio, by radio serial number, when it
is first established in the radio network. No two radios may have the same UID.
(a) General - This menu allows the user to modify the General MDC system settings.
(b) DOS – This menu allows the user to modify the DOS settings for the MDC System.
Publication
No. 150-041102 Page 57 of 88
Rev E C-5000 Operators Manual