User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
H. DTMF – This is used to configure the DTMF (Dual Tone Multiple Frequency) options.
(1) DTMF Call List – This allows you to select which DTMF Call List to be used for the
Conventional personalities.
(2) DTMF System – These menus allow you to modify the settings for the DTMF System.
(a) General – This menu allows you to modify the General settings of the DTMF System.
Publication
No. 150-041102 Page 61 of 88
Rev E C-5000 Operators Manual