User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
(a)
General – This menu allows you to modify the General settings of the Trunking System.
(b) Type II – This menu allows you to modify the Type II Trunking Setting when Type II is
selected in the General menu.
(c) DTMF- This menu allows you to modify the DTMF settings for the Trunking System.
(d) Aliasing – This menu allows you to modify the Aliasing setting for the Trunking System.
(e) Message Alias – This menu allows you to modify the Message Aliasing settings for the
Trunking System.
(f) Status Alias – This menu allows you to modify the Status Aliasing settings for the
Trunking System.
(g) Site Alias – This menu allows you to modify the Site Aliasing settings for the Trunking
System.
Note:
These fields should be set to DISABLED.
(h) Advanced – This menu allows you to modify the Advanced settings for the Trunking
System.
Publication
No. 150-041102 Page 69 of 88
Rev E C-5000 Operators Manual