User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
(10) Preferred Sites – This menu allows you to select the Preferred Sites for the Trunking
Personality.
(11) Emergency Revert – This menu allows you to modify and select the Emergency Revert
function for the Trunking Personality.
D. Trunking Call List – This is used to create trunking call lists.
E. Type II Trunking Call List – This is used as an advanced feature of the trunking system which
allows talkgroups to be set-up as trunking channels.
11. Scan
– These menus contain elements that affect the scan mode. This feature is currently not used
in the FLEXCOMM System.
Publication
No. 150-041102 Page 76 of 88
Rev E C-5000 Operators Manual