User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
Appendix B – Mode 2 Operation
Overview
The C-5000 has the capability to control the RT-5000 in such a way that the user can monitor both the
main and the Guard (ITM) channel at the same time. This mode of operation is more difficult to use than
MODE 1.
The Home Page
The only visible difference in the HOME PAGE from Mode 1 operation is in the Main/Guard status fields.
The illustration below depicts the HOME PAGE for a system comprised of two digital RT-5000 radios.
Both radios are configured to operate in Mode 2. The Main transceiver is the active transceiver on radio
1. The digital transceiver (Guard) is the active transceiver on radio 2. The active transceiver is the one
that will transmit when the push-to-talk switch is depressed.
1 1
1 2 3
LUKEAFB T
W
R 1
2 2
. . 1 T A C T I C A L - 0 0 1
Guard Status Indicators
Main Status Indicators
Main/Guard Status Fields – These fields display symbols indicating the current status of all the
available transceivers in the system. The symbols are as follows.
. – Indicates a radio is available, but not enabled.
► – Indicates a radio is transmitting.
1 – Indicates Main/Guard 1 is available and enabled, but not active.
2 – Indicates Main/Guard 2 is available and enabled, but not active.
1 – Indicates Main/Guard 1 is available, enabled, and active.
2 – Indicate
s Main/Guard 2 is available, enabled, and active.
1 – Indicates Main/Guard 1 is receiving.
2 – Indicates Main/Guard 2 is receiving.
Publication
No. 150-041102 Page 81 of 88
Rev E C-5000 Operators Manual