User's Manual
Table Of Contents
- 150-041102_doc
- Section Page
- Section Page
- 1. Applicability
- 2. Glossary
- 3. Introduction
- 4. Configuration Availability
- 5. Configuring the C-5000
- A. Configuring the C-5000
- 6. CPS Software Description and Programming
- A. Before You Begin
- There are (2) versions of CPS that may apply to the RT-5000 depending upon P/N as follows:
- 9. Conventional - All the aspects of any given channel are assigned to a personality numbered 1 through 255. These menus allow the user to modify the settings for the Conventional Personalities.
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
- Appendix C – Single Microphone Operation
- Appendix D – Equivalent Part Numbers
- Appendix D – Equivalent Part Numbers (cont’d)
FLEXCOMM II
C-5000 (P-25 Capable)
Operator’s Manual
(11) Advanced – This menu allows you to modify complex features of the Conventional
Personality. These options are left DISABLED.
(12) ASTRO – This menu allows you to modify the Conventional Personality’s ASTRO
parameters.
(13) ASTRO Call – This menu allows you to modify the Conventional Personality’s ASTRO
System functions.
(14) ASTRO Talkgroup Options – This menu allows you to modify the Conventional Personality’s
ASTRO System Talkgroup List functions.
(15) Quick-Call II – This menu allows you to modify the Call Alert and Selective Call parameters
for the Conventional Personality.
(16) DTMF – This menu allows you to modify the Call Alert tones for the Conventional Personality.
D. Message Alias List – This is used to configure various short messages to send via the radio.
This feature is currently not used in the FLEXCOMM System.
Publication
No. 150-041102 Page 56 of 88
Rev E C-5000 Operators Manual