Instructions

Table Of Contents

9.2.2 Cleaning and washing

Do not clean the product. Any residue cannot be easily removed by washing. Use a "no

clean" soldering paste and do not clean the board after soldering.

• Washing agents used during the production to clean the customer application might

damage or change the characteristics of the component. Washing agents may have a

negative effect on the long-term functionality of the product.

• Using a brush during the cleaning process may damage the component. Therefore,

we do not recommend using a brush during the PCB cleaning process

9.2.3 Potting and coating

• Potting material might shrink or expand during and after hardening. This might ap-

ply mechanical stress on the components, which can inﬂuence the characteristics of

the transfer function. In addition, potting material can close existing openings in the

housing. This can lead to a malfunction of the component. Thus, potting is not recom-

mended.

• Conformal coating may affect the product performance. We do not recommend coating

the components.

9.2.4 Storage conditions

• A storage of Würth Elektronik eiSos products for longer than 12 months is not rec-

ommended. Within other effects, the terminals may suffer degradation, resulting in

bad solderability. Therefore, all products shall be used within the period of 12 months

based on the day of shipment.

• Do not expose the components to direct sunlight.

• The storage conditions in the original packaging are deﬁned according to

DIN EN 61760 - 2.

• For a moisture sensitive component, the storage condition in the original packaging

is deﬁned according to IPC/JEDEC-J-STD-033. It is also recommended to return the

component to the original moisture proof bag and reseal the moisture proof bag again.

9.2.5 Handling

• Violation of the technical product speciﬁcations such as exceeding the nominal rated

supply voltage, will void the warranty.

• Violation of the technical product speciﬁcations such as but not limited to exceeding

the absolute maximum ratings will void the conformance to regulatory requirements.

• ESD prevention methods need to be followed for manual handling and processing by

machinery.

• The edge castellation is designed and made for prototyping, i.e. hand soldering pur-

poses only.

Differential Pressure Sensor, Part Nr. 25131308xxx01