Instructions

1 General description
1.1 Introduction
This evaluation board provides a straightforward and cost-effective option to test and evalu-
ate the differential pressure sensors from Würth Elektronik eiSos. It can be connected to the
host controller (e.g. Arduino) using I
2
C interface pins. Through hole pin header connections
allow the board to be mounted on a bread board.
The differential pressure sensor (Part No: 25131308xxx01) is a MEMS based 15-bit piezo-
resistive pressure sensor with a digital I
2
C and an analog interface. The sensor evaluation
board is available in five pressure measurement ranges from 0.1 kPa to 1000 kPa (See
table 1 . In addition to the sensor and decoupling capacitors, the evaluation board consists
of a mounted adapter with two nozzles. Pneumatic tubes can be connected to the nozzles.
Barbed nozzle design improves the overall mechanical stability of the connection.
Figure 1: Evaluation board for the differential pressure sensor
1.2 Ordering Information
WE order code
Pressure range
[kPa]
Sensor Marking
Dimensions
[mm]
Description
2513254510091 ± 0.1 PDB100IA0N
2513254510191 ± 1 PDB101IA0N
2513254510291 ± 10 PDB102IA0N
2513254510391 0 to 100 PDU103IA0N
2513254510491 -100 to 1000 PDU104IA0N
45 x 25 x 31
ESD bag
packaging
Table 1: Ordering information
Differential Pressure Sensor Evaluation Board, Part Nr. 25132545xxx91
User manual version 1.0 © October 2019
www.we-online.com/sensors 4