Datasheet

User’s Manual
Page 10 of 15
This document is only valid on the
date of printing: 2016-10-26
WERI Mini Applicator
I:\Specs\eiCan\WERI\ConTOOLC\Datasheet\User's Manual_WERI Mini Applicator.docx
7.2 Feeding (qualified technician only)
For adapting the pawl B to the pitch of the terminals, in order to have a new terminal correctly
placed on the anvil for each cycle of the press: loosen the nut A and move the screw up for a
greater pitch or down for a shorter one. Then tighten the nut again.
The -10 to +10 scale is indicative and only serves to store the screw position once
properly adjusted.