Datasheet

User’s Manual
Page 11 of 15
This document is only valid on the
date of printing: 2016-10-26
WERI Mini Applicator
I:\Specs\eiCan\WERI\ConTOOLC\Datasheet\User's Manual_WERI Mini Applicator.docx
7.3 Crimping axis (qualified technician only)
This adjustment serves to perfectly align the terminal on the anvils and punches axis.
Manually cycle the press by means of a spanner until the terminal is positioned on the anvil. Loosen
the nut A and turn the screw clockwise or counter-clockwise to determine the correct position. Then
tighten the nut again and make a complete cycle of the press. If the result is not satisfying enough,
repeat the operation.
7.4 Bellmouth and cut-off tab (qualified technician only)
For adjusting the bellmouth, loosen the screw B to release the wedge D and the terminal slide A.
Rotate screw C clockwise or counter-clockwise to obtain the desired adjustment. Tighten B again
until D blocks A.
Performing this operation may change the cut-off tab length. In case it needs to be readjusted,
remove the mini applicator from the press, loosen the screw E and move the lower group of
crimping elements backwards or frontwards. Then tighten E again.