Datasheet

User’s Manual
Page 3 of 15
This document is only valid on the
date of printing: 2016-10-26
WERI Mini Applicator
I:\Specs\eiCan\WERI\ConTOOLC\Datasheet\User's Manual_WERI Mini Applicator.docx
2 Important warnings
Verify the press shut height setting by means of a shut height gauge: 135.8 mm at bottom dead
center.
Verify that the press and the mini applicator’s axis are perfectly in line.
Set the top ring of the continuous adjusting head in accordance with the data on the identification
plate.
After having installed the mini applicator, cycle manually the press by means of a spanner in order
to check that:
- the mini applicator runs smoothly without sticking in any way;
- the terminal is correctly placed on the anvil, in line with the same and the other crimping
and cutting parts.
NOTE: each mini applicator is dedicated only to the terminal(s) written on its identification plate.
Each mini applicator come in already configured with respect to that(those) terminal(s). After
installation only the crimping heights need to be adjusted to the wire to be crimped. Any other
operation / adjustment / setting should only be made and recorded by a qualified and experienced
technician.