Datasheet

User’s Manual
Page 6 of 15
This document is only valid on the
date of printing: 2016-10-26
WERI Mini Applicator
I:\Specs\eiCan\WERI\ConTOOLC\Datasheet\User's Manual_WERI Mini Applicator.docx
6 Installation (trained operator)
6.1 Installing the mini applicator inside the press
Make sure to turn off the press before performing the following steps.
Mini applicators are delivered with a rubber spacer inserted between the continuous adjusting head
and the body for protection during transportation. Remove it when installing the applicator.
Place the mini applicator on the fixing plate A, line up the magnum’s D base with the B hooks and
tighten up the knob C.
Verify that the mini applicator is flat on the fixing plate A and make sure that the mini applicator’s E
pin is perfectly centered with reference to the press’ “T “ shank.