Datasheet

User’s Manual
Page 7 of 15
This document is only valid on the
date of printing: 2016-10-26
WERI Mini Applicator
I:\Specs\eiCan\WERI\ConTOOLC\Datasheet\User's Manual_WERI Mini Applicator.docx
6.2 Inserting the terminals into the mini applicator
With reference to the identification plate, position the top ring of the continuous adjusting head
according to the settings related to the maximum wire cross section allowed.
Free the brake by means of the lever B, place the terminals in the guide A, push it until it will be
hooked by the pawl C and then tighten the brake by means of the lever B.
After having installed the mini applicator, manually cycle the press by means of a
spanner, in order to check that:
- the mini applicator runs smoothly without sticking in any way;
- the terminal is correctly placed on the anvil, in line with the same and the other crimping
and cutting parts. If further adjustments are needed, please refer to the following
paragraphs.