MANUAL 200 W DEVEL PMENT KIT Wireless Power Transfer Extended Medium Power Solution Order Code 760308EMP
00 W Development Kit – Extended Medium Power Solution for Wireless Power Transfer Transmitter Board and Receiver Board Abstract K ey Specification Infineon and Würth Elektronik eiSos (WE) offer this wireless power development kit (order code 760308EMP) to demonstrate the advantages of wireless power and to give developers the opportunity to test and integrate a wireless power solution into their application. This manual describes the setup and basic usage of this development kit.
Table of Contents At a glance...................................................................................................................................... 2 Abstract ..................................................................................................................................... 2 Description of Featured Products ................................................................................................. 2 Key Specification ..................................................
1. Introduction 2. Hardware Description This manual is valid for development kit version 1.0. It provides guidelines to quickly setup the hardware for fast and easy evaluation of the wireless charging system and the featured key components. For further details and updates about the used parts, please consult the relevant product datasheets and general information at www.we-online.
The receiver board integrates all necessary functions to act as a wireless power receiver such as full synchronous rectification, modulator and a WE MagI³C Power Module. The modulator is used for data transfer. It is controlled by the MCU to send data from receiver side to transmitter side.The receiver is equipped with an I²C interface that can be used to interface to sensors. The sensor interface has its own adjustable power supply. 2.
All cables or connectors used must offer adequate insulation and operation in order that the requirements of the relevant performance and safety are met. The connection of incompatible devices to the development kit can cause serious damage to the unit. WARNING 3.3 Power supply Apply one of the included mains plugs (North America / Japan, Great Britain, Central Europe) to the power supply connector and connect the AC plug to mains.
4. Transmitter board 5. Receiver board Parameter Specification Input voltage 24 VDC Output voltage Max. 24 VDC Input current Max. 10 A Output current Max.
6. Step by step installation guide for 200 W development kit Step 1: Install software tools Install DAVE™ DAVE™ is a free and powerful Eclipse-based development platform for XMC™ software development. DAVE™ includes GCC compiler from GNU, DAVE™ code engine for automatic code generation and GDB debugger from GNU. DAVE™ offers pre-defined and tested SW components -DAVE™ APPs- and XMC™ Lib-Low Level Drivers (LLDs) – that accelerate the application software creation.
S1 A/M Jumper position for manual mode Figure 7: Jumper setting for manual or automatic mode Step 4: Apply power When the setup is finished, input power can applied. The DC-OK LED on the transmitter is on. Now the system is in standby mode. To start/stop the wireless power transfer press S1 (see figure 7). 7. Customer Support If any further technical supports required when operating with the development kit please contact Würth Elektronik eiSos with your questions. wirelesspower@we-online.
Infineon and Würth Elektronik eiSos (later defined as WE) provide the enclosed DEVELOPMENT KIT under the following conditions: The user has to bear all responsibility and liability for the proper and safe handling with regard to this DEVELOPMENT KIT. The user shall indemnify Infineon and WE from all claims arising from the handling or utilization of the DEVELOPMENT KIT.
