User's Manual

Chapter 13 Filter 149
Rule Type Select IP to filter traffic by IP addresses.
Select MAC to filter traffic by MAC address.
Source IP Address Enter the source IPv6 address of the packets you wish to filter. This field is ignored if it
is ::.
Subnet Mask Enter the IPv6 subnet mask for the source IPv6 address.
Source Prefix
Length
Enter the prefix length for the source IPv6 address.
Destination IPv6
Address
Enter the destination IPv6 address of the packets you wish to filter. This field is ignored
if it is ::.
Destination Prefix
Length
Enter the prefix length for the destination IPv6 address.
ICMPv6 Type Select one of the following ICMPv6 message types to filter.
1 / Destination Unreachable: 0 - no route to destination; 1 - communication with
destination administratively prohibited; 3 - address unreachable; 4 - port unreachable
2 / Packet Too Big
3 / Time Exceeded: 0 - hop limit exceeded in transit; 1 - fragment reassembly time
exceeded
4 / Parameter Problem: 0 - erroneous header field encountered; 1 - unrecognized
Next Header type encountered; 2 - unrecognized IPv6 option encountered
128 / Echo Request
129 / Echo Response
130 / Listener Query - Multicast listener query
131 / Listener Report - Multicast listener report
132 / Listener Done - Multicast listener done
143 / Listener Reportv2 - Multicast listener report v2
133 / Router Solicitation
134 / Router Advertisement
135 / Neighbor Solicitation
136 / Neighbor Advertisement
137 / Redirect - Redirect message
Protocol This is the (upper layer) protocol that defines the service to which this rule applies. By
default it is ICMPv6.
Source MAC
Address
This field is only available when you select MAC in the Rule Type field.
Enter the MAC address of the packets you wish to filter.
IPv6 / MAC Filter Listing
Table 58 Security > Filter > IPv6/MAC Filter (continued)
LABEL DESCRIPTION