User's Manual
Table Of Contents
- DSL-100HNU-T1 v3 User’s Guide
- Contents
- Introduction
- Introducing the Web Configurator
- Quick Start
- Connection Status and System Info
- WAN Setup
- Wireless
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
- Dynamic DNS
- Filter
- Firewall
- Parental Control
- Certificates
- System Monitor
- User Account
- TR-069 Client
- System
- Time Setting
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Remote Management
- Diagnostic
- Troubleshooting
- Legal Information
19
Chapter
Chapter 19 TR-069 Client 189
CHAPTER 19
Chapter 19
TR-069 Client
19.1 Overview
This chapter explains how to configure the Device’s TR-069 auto-configuration settings.
19.2 The TR-069 Client Screen
TR-069 defines how Customer Premise Equipment (CPE), for example your Device, can be managed
over the WAN by an Auto Configuration Server (ACS). TR-069 is based on sending Remote Procedure
Calls (RPCs) between an ACS and a client device. RPCs are sent in Extensible Markup Language (XML)
format over HTTP or HTTPS.
An administrator can use an ACS to remotely set up
the Device, modify settings, perform firmware
upgrades as well as monitor and diagnose the Device. You have to enable the device to be managed
by the ACS and specify the ACS IP address or domain name and username and password.
Click Maintenance > TR-069
Client to open the following screen. Use this screen to configure your
Device to be managed by an ACS.
Figure 124 M
aintenance > TR-069 Client