User's Manual

Chapter 19 TR-069 Client 190
The following table describes the fields in this screen.
Table 79 M
aintenance > TR-069 Client
LABEL DESCRIPTION
CWMP Select Enabl
e to allow the Device to be managed by a management server. Otherwise,
select Disable to not allow the Device to be managed by a management server.
ACS URL Enter the URL or IP address of the auto-configuration server.
ACS User
Name
Enter the TR-069 user name for authentication with the auto-configuration server.
ACS Password Enter the TR-069 password for authentication with the auto-configuration server.
Connection
Request Path
Type the IP address or domain name of the Device. The
management server uses this path
to verify the Device.
Connection
Request Port
The default port for access to the Device from the management server is the HTTP port,
port 80. If you change it, make sure it does not conflict with another port on your network
and it is recommended to use a port number above 1024 (not a commonly used port). The
management server should use this port to connect to the Device. You may need to alter
your NAT port forwarding rules if they were already configured.
Connection
Request User
Name
Enter the connection request user name.
When the ACS makes a connection request to t
he Device, this user name is used to
authenticate the ACS.
Connection
Request
Password
Enter the connection request password.
When the ACS makes a connection request to t
he Device, this password is used to
authenticate the ACS.
Inform Select Enabl
e for the Device to send periodic inform via TR-069 on the WAN. Otherwise,
select Disable.
Inform
Interval
Enter the time interval (in seconds) at which the Device sends information to the auto-
configuration server.
Apply Click Apply to save your chan
ges.
Cancel Click Ca
ncel to restore the screen’s last saved settings.