User's Manual
Table Of Contents
- DSL-100HNU-T1 v3 User’s Guide
- Contents
- Introduction
- Introducing the Web Configurator
- Quick Start
- Connection Status and System Info
- WAN Setup
- Wireless
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
- Dynamic DNS
- Filter
- Firewall
- Parental Control
- Certificates
- System Monitor
- User Account
- TR-069 Client
- System
- Time Setting
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Remote Management
- Diagnostic
- Troubleshooting
- Legal Information
Chapter 24 Backup/Restore 202
Reset to Factory Defaults
Click the Reset bu
tton to clear all user-entered configuration information and return the Device to
its factory defaults. The following warning screen appears.
Figure 134 Reset
Warning Message
Figure 135 Reset In Process Message
You can also press the RESET button on the back panel to reset the factory defaults of your Device.
Refer to Section 1.6 on page 12 for more information on the RESET bu
tton.
24.3 The Reboot Screen
System restart allows you to reboot the Device remotely without turning the power off. You may
need to do this if the Device hangs, for example.
Click Main
tenance > Reboot. Click the Reboot button to have the Device reboot. This does not
affect the Device's configuration.