User's Manual
Table Of Contents
- DSL-100HNU-T1 v3 User’s Guide
- Contents
- Introduction
- Introducing the Web Configurator
- Quick Start
- Connection Status and System Info
- WAN Setup
- Wireless
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
- Dynamic DNS
- Filter
- Firewall
- Parental Control
- Certificates
- System Monitor
- User Account
- TR-069 Client
- System
- Time Setting
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Remote Management
- Diagnostic
- Troubleshooting
- Legal Information
Chapter 25 Remote Management 206
25.3 Telnet Screen
You can use Telnet to access the Device’s command line interface. Specify which interfaces allow
Telnet access and from which IP address the access can come.
Click Main
tenance > Remote MGMT > Telnet tab to display the screen as shown.
Figure 138 Ma
intenance > Remote MGMT > Telnet
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the Device
using this service.
Select Al
l to allow any computer to access the Device using this service.
Choose Range to
just allow the computers with an IP address in the range that you
specify to access the Device using this service.
Apply Click this to save your changes.
Cancel Click this to restore your pr
eviously saved settings.
Table 85 Maintenance > Remote MGMT > WWW (continued)
LABEL DESCRIPTION